PRO-HD-W/O PulseTech 12/24-Volt Charger Battery Recovery Unit

PRO-HD-W/O PulseTech 12/24-Volt Charger Battery Recovery Unit

SPCS/C 24V PulseTech 24V Battery Charger System With Case

SPCS/C 24V PulseTech 24V Battery Charger System With Case

24-Volt Dual Two-Station Pulse Charger®

Charge and maintain twice the number of 24-Volt lead-acid batteries simultaneously with the 24-Volt Dual Two-Station Pulse Charger. If you work in a shop or facility that services any vehicles or equipment that use 24-Volt electrical systems, you need this state-of-the-art charging system to return batteries to peak levels and to eliminate sulfation buildup - the main cause of battery failure. Works off either 110- or 220-Volt AC power on 24-Volt lead-acid flooded, VRLA and AGM and gel batteries. NSN 6130-01-609-9818

NSN 6130-01-609-9818

The Two-Station 24-Volt Pulse Charger reduces battery-related equipment down time and maintenance time. This state-of-the-art charging system works with 24-Volt lead-acid VRLA, AGM, gel and flooded batteries and uses either 110- or 220-Volt AC power so it can be used anywhere in the world. It comes in a portable, heavy duty case so you can take it wherever it's needed.

The voltage and current regulated, microprocessor controlled charger will provide all the charge needed to charge a battery to the optimum level regardless of the rated amp-hour capacity or rated cold cranking amps by constantly monitoring the battery and adjusting the charging current (up to 3.5 Amps per output). When the optimum level is reached, the charger switches to float mode so the battery cannot be overcharged, no matter how long it's left connected.

Throughout the charging process, the Pulse Charger continuously emits a series of high frequency pulse shaped waves of DC current to reduce sulfation buildup -- the main cause of battery failure. Sulfation buildup occurs as lead sulfates form on the battery plates during the normal charge/discharge cycles, even on new batteries. These energy-robbing deposits can reduce the battery's ability to accept and keep a charge until the battery dies. Our patented Pulse Technology breaks down these deposits to improve the performance and extend the life of your batteries.

This product has a new Green Mode feature. When AC power is applied and no batteries are connected, the microcontroller will shut off the DC side of the charger reducing input power consumption to less than 1 Watt. When a battery is connected the unit will immediately wake up and start the charging process. Green mode operates independently for both charger outputs.

Both stations on the 24V Dual operate in isolation from one another, allowing any combination of battery brands to be recharged at the same time. Colored LEDs next to each station indicate the battery's state of charge at 25%, 50%, 75% and 100% as well as when the charger is charging and pulsing and when the battery is bad and cannot be recharged.

• Charges and maintains 24-Volt lead-acid VRLA, AGM, gel and flooded batteries
• Two-stations for twice the capability
• Desulfating pulses extend battery life
• Reverse battery protection and indication
• Sparkless operation
• Quick disconnect at battery
• Over temperature protection
• Output current limit protection
• Heavy duty clamp type battery cables
• Green mode feature
• One-Year Warranty

Model Number: 24V DUAL
Part Number: 746X840
NSN: 6130-01-609-9818

Electrical Characteristics
Input Electrical
Input Voltage: 100VAC to 240VAC
Input Current: 2.33 Amps Max (@100VAC in and I-out = 3.5Amps x 2)
Input Frequency: 50 – 60 Hz
Minimum Battery Voltage for Charger Startup: ≥ 14 Volts

Output Electrical
Output Current: 3.5 Amp Max per output
Output Voltage, Bulk Charge: 30 Volts
Absorption to Float Charge Threshold 24 V: Battery Voltage = 28.4V Under Charge and Charge Current < 1.0 A DC
Desulfating Pulse Peak Amplitude: 1.5A Typical
Desulfating Pulse Frequency: 11kHz
Pulse Rise Time: < 1 microsecond

Mechanical / Physical Characteristics
Shipping Dimensions: 15'' x 12'' x 8''
Shipping Weight: 11 lbs.
Power Cord Length: 6'
Battery Clamp Cable Length: 6' each

Operating Temperature: 0º F to 130 º F (-18º C to 54º C)
Storage Temperature: 0º F to 150 º F (-18 º C to 66 º C)

Battery’s state of charge: 25%, 50%, 75% and 100%
Power On
Charge Complete
Bad Battery
Warranty: One-Year Limited Warranty

Write Your Own Review
You're reviewing:24-Volt Dual Two-Station Pulse Charger®